GrowerSELECT® Installation Manuals Binder

Hog Slat Inc. Newton Grove, NC USA May 2017 45 GROW-DISK ™ Feed System 6. First system start-up (1 hour) o When accurate chain tension is achieved, remove the tape from the Door switch. o Reset Chain Safety Switch (pull blue button) o Place cover on drive unit and secure. o Make sure GROW-FLEX™ AUGER System is turned OFF! o All slides of any outlet or sow drop must be open! o Start the Grow Disk System and let it run for min. 1 hour o During operation inspect all corners, fill hopper, outlet and sow drops for unusual vibrations or sounds! If so, stop system immediately and check installation of the affected part! 7. Controller and Proximity Switch adjustments o After successful system start-up , turn on the GROW-FLEX™ AUGER System o A ll slides at the feed tank unloaders are remain closed! o Close all sliders of any outlet or sow drops. o Restart system in automatic mode o Check setup e.g. delay start of flexible auger, maximum runtime etc. o Check setup and function of proximity switch o Make setup adjustment if necessary 8. Seal all Corners o Turn off the drive unit and disconnect all electircal power o Follow instructions for Corner sealing on page 16 o DO NOT restart the system for 1 ½ hours after sealing is completed! o Turn on the power and make sure that the controller is reset and in automatic mode. o Turn on the GROW-FLEX™ AUGER System o Open the slide at only 1 feed tank unloader!