AirStorm - AS-57 Pro Series Fan Installation Manual

Hog Slat Inc. Newton Grove, NC USA January 2025 16 Air Storm Fans The IP55 rating is ensured when all conduits to the motor are used and connected properly to incoming electrical power and signal lines. When installing motor a drip loop is recommended to ensure IP55 rating Prop must be secured during installation. Shaft rotation generates voltage at terminals, even when power is disconnected. RATING All associated documentation applies to 2.28HP model designed to operate from 1Φ, 230 Vac, 60/50Hz. Rated Shaft Output Power: 2.28HP Rated Speed: 700 RPM Unloaded (In application rated speed: 618) Rated System Input Current: 8.5 Amps Protection and Faults: Locked Rotor Fault: Output Overcurrent: If the motor draws more than 8.5 Amps the drive will decrease RPM and limit to 8.3 Amps until the amp load decreases. Once load decreases motor will return to desired RPM Output Wattage Limit: If motor wattage exceeds 2210 Watts the drive will decrease RPM and limit motor to an output below 2210 Watts. Once load decreases motor will return to desired RPM Over Temperature: If the motor temperature exceeds 97°C (206.6°F) the motor will reduce RPM. Motor returns to selected speeds after temperature drops. The motor may experience multiple speed decreases if the temperature does not fall between temperature checks (Approximately 60 second interval).

RkJQdWJsaXNoZXIy MTA3MzU=