Hog Slat Inc. Newton Grove, NC USA January 2025 9 Air Storm Fans After the fan is mounted to the wall verify that the prop hub is flush with end of the motor shaft and motor is mounted as far forward as possible. Spin prop by hand and ensure correct prop clearance. At this time also inspect tightness of fit of the butterfly to the orifice. OI The following step is optional. If desired, the butterfly assembly may be removed and included sponge gasket can be installed around the outermost circumference of the orifice and the butterfly assembly reinstalled. IF COMPLETED ENSURE CORRECT ORIENTATION OF THE BUTTEFLY FROM STEP 2. 4. From inside the house, the butterfly springs are attached to the butterfly doors using hardware for bag number 13. There are 2 sets of predrilled holes in each butterfly door. Insert bolt as shown below though closest hole to center upright and secure with washer and lock nut. Attach both springs to center upright bolt and secure with lock nut, then attach opposite ends of springs to bolt that was added to the door again securing with a lock nut. 5. Assemble cone. This step requires (2) installers. Begin by placing one cone panel on the ground with the end with connection slots slightly elevated. Insert the connection tabs into the connection slots and rotate to parallel. Continue for all 4 panels.
RkJQdWJsaXNoZXIy MTA3MzU=