GrowerSELECT - HS820 Infrared Feed Controller Installation Manual

Hog Slat Inc. Newton Grove, NC USA MARCH 2023 REV A6 4 GROW-FLEX™ Feed Systems 3. GENERAL INSTALLATION NOTES: Make sure that power is disconnected from system prior to servicing. Installation of this equipment and related OEM equipment should be in accordance with these instructions, OEM’s installation instructions and local codes (if applicable). Failure to follow specified instructions may cause damage to equipment and/or personal injury or death. Take special note of any Warnings or Safety Decals on the equipment and in manuals. Always wear protective clothing and any applicable Personal Protective Equipment (Safety Glasses and/or Ear Plugs) when working with the equipment. Discarded materials, equipment and boxes should be recycled in accordance with local and national codes. Note: Controller is to be wired in accordance with all applicable local and national electrical wiring codes. All wiring sizes and fuse capacities are to be sized according to applicable electrical code specifications or other regulations. 4. SAFETY INSTRUCTIONS: Read all safety messages in this manual and on equipment safety decals. Follow recommended precautions and safe operating practices. Pay Attention. Take the time to read and understand this as it may save you time later. Recommended operating temperature range is between 0° C and 40°C (32104°F). Do not place controller near water lines. A switch or circuit breaker must be included in the installation. Place controller in a suitable and easily reached location. Warning: Disconnect power before servicing. Warning: DO NOT PRESSURE WASH. PROTECT UNIT DURING ROOM CLEANING.

RkJQdWJsaXNoZXIy MTA3MzU=