Hog Slat Inc. Newton Grove, NC USA MAY 2026 REV A3 11 Ventilation System SECTION 9: INITIAL START UP OF CONTROLLER Upon the first power up of the controller, the controller is not enabled. This allows user to perform minimal set up of stages so that when the controller is enabled all stage outputs are assigned to the appropriate type devices. On the initial screen a notification will be shown indicating an initial set up is required. Press the MENU button. This will go to the HOME screen. Go through the below listed highlighted in blue buttons to set up the minimum parameters required. NOTE: If you choose not to perform the minimum set up, the controller will default to output stages as cooling with one Heat, Mist cooling, one probe, Stage 1 to curve “1” and non-floating Stage 3. 1. SETTINGS: Assign the appropriate motor curve for Stage 1 fan. (see section 10, item 14E and 14F)
RkJQdWJsaXNoZXIy MTA3MzU=