Hog Slat Inc. Newton Grove, NC USA SEPT 2025 REV A2 8 Ventilation System SECTION 5: REPLACING TC5 TOP BOARD 1. Disconnect power from the controller. 2. Open the front door of the enclosure by sliding the latch found on the right side upward to release the door. 3. Swing the front door assembly completely open and disconnect the ribbon cable from the bottom board. Slowly press down the release levers found on each side of the ribbon connector. Press each side a little at the time until the connector is pushed up and away from the base. 4. Carefully open the front door enclosure as far as possibly and pull the door hinges toward you until they have released from the pins in the enclosure mounted on the wall. 5. Place the new HSVC1024-2C5A assembly and align the hinges with the existing mounted enclosure. With them align carefully push the hinges onto the pins until they snap over the pins.
RkJQdWJsaXNoZXIy MTA3MzU=