Hog Slat Inc. Newton Grove, NC USA AUG 2025 REV A2 16 Ventilation System 14I. MANAGE PASSCODE: Select to manage passcode protection. PASSCODE ENABLE: Current setting is displayed. Press button to turn ON or OFF passcode protection. Once turned on, the user will be directed to create new passcode. Once passcode is created, user will not be able to navigate past the initial idle screen. FACTORY set passcode is 1234. Default passcode for the controller is 13269 in case passcode is lost. CHANGE PASSCODE: In order to change passcode. Press CHANGE PASSCODE. New pop-up screen will appear to enter OLD password first, then enter NEW password. To enter NEW passcode, simply press WHITE bar which will bring up numeric screen to enter passcode. ================================================================== 15. STAGE 1 PAGE 15A: STAGE 1 MINIMUM SPEED PERCENTAGE %: Sets the minimum speed the Stage 1 fan can operate based on percentage of full speed. 15B: MINIMUM VENT CYCLE: Set the amount of on time and off time. Stage 1 fan will follow this cycle anytime room temperature is below SET-POINT to maintain adequate ventilation. To disable cycle, set time OFF to zero. NOTE: Fan will start at full speed for 3 seconds then drop to the minimum speed setting anytime the fan turns on. Minimum vent cycle begins at 0.3F [.17C] degrees below set point 15C: HUMIDITY COMPENSATION: Stage 1 fan speed can be automatically increased based on relative humidity levels. Humidity probe is required for this operation. The compensation percentage is the amount of speed increase. Once the humidity is greater than the “Humidity level set point”, the speed of the stage 1 fan will proportionally increase until the humidity is 10% greater than the set point at which time the fan will be running at 15A 15B 15C
RkJQdWJsaXNoZXIy MTA3MzU=