Hog Slat Inc. Newton Grove, NC USA MAY 2026 REV A3 7 Ventilation System Warning: Disconnect power before servicing. Warning: DO NOT PRESSURE WASH. PROTECT UNIT DURING ROOM CLEANING.. SECTION 5: REPLACING TC5 TOP BOARD 1. Disconnect power from the controller. 2. Open the front door of the enclosure by sliding the latch found on the right side upward to release the door. 3. Swing the front door assembly completely open and disconnect the ribbon cable from the bottom board. Slowly press down the release levers found on each side of the ribbon connector. Press each side a little at the time until the connector is pushed up and away from the base.
RkJQdWJsaXNoZXIy MTA3MzU=