AP®/Cumberland® Universal Proximity Feed Sensor

Universal proximity feed sensor. Push button settings. Does not include mounting grommet.

OPERATING VOLTAGE: 24 Volts to 240 Volts AC or DC

FREQUENCY: 45 Hz to 65 Hz

MAXIMUM LOAD CURRENT: 0.2 Amps AC or DC

CONTACTS: N.C. - Normally Closed - (Brown and Red Wires) N.O. - Normally Open - (Brown and Orange Wires) NOTE: Any wire not used must be taped for protection.

CORD: 18 AWG, 3 Conductor, Type TC, Length - 6'

SENSING DISTANCE ADJUSTMENT: Sensitivity AP-2983 Factory Setting 4 (Range 1 to 6)

TIME DELAY RANGE: 0 Seconds to 3 Hours in 1 minute increments

ADJUSTMENT METHOD: “Min” push button and “Hr” push button

INDICATOR LIGHTS: Red LED On - Program Mode Yellow LED On - Product Detected Green LED Flash - Delay before Relay is Activated Green LED On - Relay Activated

INSTALLATION: Rubber mounting grommet (AP-1004) with cable tie to secure sensor to grommet. NOTE: Do not use hose clamp. 1-7/16" Diameter hole required for grommet. Insert sensor through grommet up to “GROMMET INSERTION LINE”.