Shop Online

Electric ceiling winch for use with straps (cable-free) or cable winch systems.

Place at the bottom of curtain opening to allow extra room for curtain to drop completely.

Gasolec® 3/8" gas hose with adapter. 10 feet length.

The standard in fly baits for over 40 years, Golden Marlin® attracts and controls nuisance flies right down to the last grain of bait.

Bin lid roof cap for GSI® BFT and GHT bulk feed bins. Cap only. 22" diameter.

Replacement shaft nut with insert for Hot Shot electric livestock prod shafts.

Manual gas shut off valve for all LB White® heaters.

The Plasson Universal Pressure Regulator delivers a 5-60 PSI adjustable pressure range—enabling a high-flow rate capacity at any selected pressure setting.

(Key 40-7-100) Pump cylinder for the Gator-XL medicator. Pumps a 1:100 ratio.

PVC pipe barb fitting. 1/2" FPT with 5/8" width barb end.

(Part # 16) Sampson Pivot Bar 63-1/2'' For A 7'6'' Crate for Sampson farrowing crate (painted)

Replacement coil for 1" solenoid valve 110V (Item # 60361).

The elite show stick on the market today! Constructed from high-end carbon fiber material commonly used for aerospace parts. Carbon fiber is five times stronger than steel, yet features a feather-light feel that is 25% lighter than aluminum sticks. It has incredible flex characteristics that can bow but will not kink or dent. All this in a beautiful high gloss checkered translucent pattern appearance.

Thermalarm 3 Temperature Gauge - Critical Temperature gauges available in normally open or normally closed models.

Twist lock connector, 15 Amp 220 Volt. NEMA L6-15R. Black and white. Priced each.

Wean to finish mat helps get pigs off to a good start by keeping them dry and reducing feed waste.

1/2" Nut Stainless Steel

Right Hand Side of 110V Relay (left side in the picture) for Diversified® Inlet/Vent Machine

3/16" galvanized 7x19 extra flexible aircraft cable rolls.

(Part #6) 3/16" x 3/4" Zinc Pin Slotted Roll Spring for Tong Stik

3/4" barb x 3/4" female garden hose thread brass connection fitting.

3-1/2" bottom latch clip used with flipper latch gate systems. Unpainted.

(Part # 15) Bracket Cone Support SS 57" Fan

6" V-groove cast iron wheel replacement for scraper system corner bracket assemblies.